|
Post by CalsXS2 on Dec 7, 2014 0:34:01 GMT -5
As some of you might remember I kinda trashed my hubs by bead blasting them with too coarse of media. Pics here. Post #9 www.xs650.com/forum/showthread.php?t=38641I tried to buff out the middles. I probably could have done the rear, but it just wasn't happening with the front. So I oppted to paint them. Which I can change at a latter date if I so decide. I used my wheel balancer and a drill. I think I should have not used the coarse Dico wheel on the outside of the hub that I was going to buff. After buffing, I can see some fine scratches. I might go ahead and figure out a way to hook up the drill to my balancer and spin the rod and then sand out the scratches. I'm not into hand sanding. But then again. I might just leave it. :laugh:
|
|